When we need to build energy-generated equipment, it is important to know what kind of generator is needed. In some cases it is necessary to have one or more different kind of generators: a heat pump or electric generator, a hybrid, a gas turbine or solar panel, etc. But in almost all cases, one single generator is the easiest and cheapest system: a gas unit. It takes very little time to get one – a few hours depending on the type of equipment, where it is located, when it is used, and in which locations you must do the work.
When I was working in an industrial facility, I decided to invest $200 on a unit that would provide me with an additional power supply for a few hours’ day. I also decided not to go to the expense of a compressor and electric motor for the generator. So I decided to go to my local power company, and have the technician come down and have me install the generator myself. For this installation, the technicians asked me what kind of machine had I installed last week. I replied “gas boiler”. “Oh, yes, we had one,” said the technician, who took my measurements for gas boiler and installed it. He said I was one of many in this facility – he had just come in after work one day, and saw a generator at the side of the driveway. “Do you think you would like a generator?”, he asked. “What do you normally call one?” I said, “a power unit”. He didn’t say much else to me. I took that as a sign that he would be interested.
In the course of my work, I had to install and start up five gas units. I also had to install two gas generators, one that ran off of hydrogen, but I did not actually run the generator in that room because it wasn’t required. For my final installation, two units were needed. The rest didn’t need electricity, they were already there after the installation process. So this was my gas unit – just like some other people had done before me.
When you see a power unit that I had installed, you can bet that it will have a big electric motor on the back. This should make the unit run more quickly. I tried to build a small unit that would be small enough that it would sit on the floor of the room. This might be possible with some small equipment, but it would require at the very least some kind of a “fibration transformer” with
free energy definition thermodynamics problems for gate, gibbs free energy equation explained pirates, free energy generator 220v 10kw, free energy diagram of glycolysis, free energy equation and reversibility principle meaning